Vehicle data

2025 Porsche 911 Carrera, 8-speed dual-clutch (US)

Published specifications of the 2025 Porsche 911 Carrera, 8-speed dual-clutch (US), each with its source, and this site’s modeled acceleration for this exact configuration. The specifications come from the manufacturer’s own documents and from public authorities. The acceleration times are calculated by this site’s model: they are not measurements and not the manufacturer’s figures.

Updated Model version 0.3.0

DraftThis page has not completed editorial review. It is hidden from search engines until it has.

Which vehicle this is

Every figure on this page belongs to one configuration: one model year, one market, one trim, one gearbox and one set of driven wheels. The trim and the engine or motor are written the way the source writes them.

Make
Porsche
Model
911
Model year
2025
Market
United States (US)
Trim
Carrera
Engine or motor
Boxer, twin-turbo 6-cylinder, 3.0 l
Powertrain
Combustion engine
Gearbox
8-speed dual-clutch
Driven wheels
Rear-wheel drive

Same name, different car

A car sold under the same name in another market is a different vehicle here, and so is another model year, trim or gearbox. Mass, power, gearing and tires can all differ, so nothing on this page should be read as applying to it.

The model year, model, gearbox and driven wheels of this configuration were checked against a second source:

FuelEconomy.gov vehicle data (vehicles.csv)U.S. Department of Energy / U.S. Environmental Protection Agency (FuelEconomy.gov)Where in the source: FuelEconomy.gov vehicle id 48589 (2025 Porsche 911 Carrera / Automatic (AM-S8) / Rear-Wheel Drive)Retrieved Nov 21, 2026

Modeled acceleration

Modeled estimate

Modeled, not measured

These times are calculated by this site’s physics model from the specifications on this page and the assumptions listed below. They have not been compared with instrumented tests of this vehicle, and they are not the manufacturer’s figures.
Data level B

Range only

The model can run, but at least one input is assumed, was transcribed only once, or has no measured basis. A range is shown, without a single most likely time.

The data level says how complete the sourced data is. It is not a measure of how close an estimate is to a measured time.

0–60 mph

3.48 – 3.89s

Varied across the assumption ranges

0–100 km/h

3.70 – 4.12s

Varied across the assumption ranges

Quarter mile

11.85 – 12.24s

Varied across the assumption ranges

Only a range is shown for this configuration: how far the result moves when the assumptions are varied across their ranges. No single most likely time is given, for the reasons listed below.

Why only a range is shown

  • Drag and rolling resistance: there are no measured road-load coefficients matched to this configuration and no drag coefficient confirmed from the manufacturer, so they are assumed.

Assumption

Assumptions used for this configuration

The published specifications do not cover everything the model needs. The inputs below are assumptions: each has a most likely value and a range over which it is varied to produce the ranges above.

Assumptions used for this configuration
AssumptionMost likely valueRange considered
Idle speed (rpm)800700 – 900
Torque at idle ÷ peak torque0.750.60 – 0.88
Power lost between peak-power speed and the rev limit0.080.02 – 0.20
Engine speed held at launch (rpm)2,0001,400 – 2,600
Gear-change time (s)0.100.05 – 0.15
Share of drive kept during a gear change0.850.60 – 1.00
Engine rotational inertia (kg·m²)0.200.10 – 0.35
Drag coefficient (Cd)0.300.26 – 0.36
Frontal area ÷ (width × height)0.840.78 – 0.88
Rolling-resistance coefficient0.0110.008 – 0.014
Loaded tire radius ÷ nominal radius0.9650.950 – 0.980
Driveline efficiency0.900.87 – 0.93
Center-of-gravity height (m)0.510.47 – 0.55
Rotational inertia per axle (kg·m²)2.21.5 – 3.5
Grip multiplier (tire and surface variation)1.000.92 – 1.08
Tire grip relative to an all-season tire1.151.05 – 1.30

Conditions of the modeled run

  • Level road, no wind, air density 1.2 kg/m³
  • Dry road: tire–road grip μ = 1.0, multiplied by the grip assumptions in the table above
  • A driver of 75 kg added to the published vehicle mass
  • Straight-line run on a closed course, timed from first movement with no 1-foot rollout
  • Model version 0.3.0

Each range runs from the 5th to the 95th percentile of 200 runs of the model, each with every assumption drawn afresh from its range.

The range is how far the result moves when the assumptions move. It is not a statistical confidence interval against measured results.

How the model works and what it assumes: methodology

Manufacturer-claimed acceleration

Manufacturer-claimed

0–60 mph

3.9s

As published by the manufacturer

992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Performance / Acceleration 0-60 (sec)Retrieved Nov 21, 2026Transcribed twice, results agree

This is the manufacturer’s own figure, taken from the source linked with it. Manufacturers time such runs under their own conditions, and this site has not established what they were, for example whether the first foot of travel is left out of the time. The figure is shown for reference only. The model is not tuned to it, and it is a different kind of number from the modeled times above, so the two are not expected to match.

Specifications and their sources

Each row gives the value, what kind of figure it is, where it comes from and how it was checked. Values are stored in SI units and shown in the units chosen in the Units menu. Where the source used another unit, the value as published is shown as well.

Engine or motor output
ItemValueKind of figureSourceCheck
Peak power
289 kWPublished as 388 hp
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Engine / Maximum power output @ engine speedRetrieved Nov 21, 2026
Transcribed twice, results agree
Engine speed at peak power
6,500 rpm
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Engine / Maximum power output @ engine speedRetrieved Nov 21, 2026
Transcribed twice, results agree
Peak torque
449 N·mPublished as 331 lb-ft
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Engine / Maximum torque @ engine speedRetrieved Nov 21, 2026
Transcribed twice, results agree
Lower end of the peak-torque speed range
2,000 rpm
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Engine / Maximum torque @ engine speedRetrieved Nov 21, 2026
Transcribed twice, results agree
Upper end of the peak-torque speed range
5,000 rpm
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Engine / Maximum torque @ engine speedRetrieved Nov 21, 2026
Transcribed twice, results agree
Rev limit
7,500 rpm
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Engine / Maximum engine speedRetrieved Nov 21, 2026
Transcribed twice, results agree
Gearing and tires
ItemValueKind of figureSourceCheck
Gear ratios, first gear first
4.89 / 3.17 / 2.15 / 1.56 / 1.18 / 0.94 / 0.76 / 0.61
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Transmission / Ratios 1st-8thRetrieved Nov 21, 2026
Transcribed twice, results agree
Final drive ratio
3.39
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Transmission / Rear Axle Ratio / rear constant transaxle ratio ('3.39 / 0.92': the first value)Retrieved Nov 21, 2026
Transcribed twice, results agree
Fixed ratio between the gearbox and the final drive
0.92
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Transmission / Rear Axle Ratio / rear constant transaxle ratio (the second value)Retrieved Nov 21, 2026
Transcribed twice, results agree
Tire size on the driven wheels
295/35ZR20
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Brakes & Wheels / Standard tire size (front/rear) (the rear value)Retrieved Nov 21, 2026
Transcribed twice, results agree
Tire type
Summer
AssumedSet from other public information
This value is not in the manufacturer’s specification document, so it was set from other public information. It is not the manufacturer’s figure for this vehicle.How such values are chosen
Entered once
Mass and dimensions
ItemValueKind of figureSourceCheck
Curb mass
1,516 kgPublished as 3,342 lb
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Dimensions, Aerodynamics, & Weight / Curb weight (lbs)Retrieved Nov 21, 2026
Transcribed twice, results agree
Share of weight on the front axle
38%
AssumedSet from other public information
This value is not in the manufacturer’s specification document, so it was set from other public information. It is not the manufacturer’s figure for this vehicle.How such values are chosen
Entered once
Wheelbase
2,450 mm
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Dimensions / Wheelbase (inches/mm)Retrieved Nov 21, 2026
Transcribed twice, results agree
Overall width
1,852 mm
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Dimensions / Width w/o mirrors (inches/mm)Retrieved Nov 21, 2026
Transcribed twice, results agree
Overall height
1,298 mm
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Dimensions / Height with standard PASM suspension (inches/mm)Retrieved Nov 21, 2026
Transcribed twice, results agree
Top speed
ItemValueKind of figureSourceCheck
Top speed
295 km/hPublished as 183 mph
ClaimedPublished by the manufacturer
992.2 911 Carrera and Carrera Cabriolet Technical Specifications (PDF)Porsche Cars North AmericaWhere in the source: Technical Data table (left column = 911 Carrera; right column is Cabriolet, not used) / Performance / Top track speed PDK (mph)Retrieved Nov 21, 2026
Transcribed twice, results agree

“Transcribed twice” means two independent readings of the source gave the same value. It confirms that the source was copied correctly, not that the source itself is right.

Comparisons with this car

Before you rely on this page

  • The modeled times have not been compared with instrumented tests of this vehicle. Read them as estimates from stated inputs, not as predictions of a measured result.
  • This site is independent. It is not affiliated with, sponsored by or approved by the manufacturer of this vehicle or by anyone who sells it. The make and model names are used only to say which vehicle the figures describe.
  • The specifications are taken one figure at a time from the sources linked above. A source can contain an error, and a manufacturer can change a specification during a model year.

If a figure on this page is wrong, or should be removed, tell us and include a source.

Report a data error

All data sources and how they are used

All comparisons

All cars