Vehicle data
2025 Ford Mustang EcoBoost, 10-speed automatic (US)
Published specifications of the 2025 Ford Mustang EcoBoost, 10-speed automatic (US), each with its source, and this site’s modeled acceleration for this exact configuration. The specifications come from the manufacturer’s own documents and from public authorities. The acceleration times are calculated by this site’s model: they are not measurements and not the manufacturer’s figures.
DraftThis page has not completed editorial review. It is hidden from search engines until it has.
Which vehicle this is
Every figure on this page belongs to one configuration: one model year, one market, one trim, one gearbox and one set of driven wheels. The trim and the engine or motor are written the way the source writes them.
- Make
- Ford
- Model
- Mustang
- Model year
- 2025
- Market
- United States (US)
- Trim
- EcoBoost
- Engine or motor
- 2.3L EcoBoost turbocharged I-4 (DOHC Ti-VCT)
- Powertrain
- Combustion engine
- Gearbox
- 10-speed automatic
- Driven wheels
- Rear-wheel drive
Same name, different car
A car sold under the same name in another market is a different vehicle here, and so is another model year, trim or gearbox. Mass, power, gearing and tires can all differ, so nothing on this page should be read as applying to it.
The model year, model, gearbox and driven wheels of this configuration were checked against a second source:
FuelEconomy.gov vehicle data (vehicles.csv)U.S. Department of Energy / U.S. Environmental Protection Agency (FuelEconomy.gov)Where in the source: FuelEconomy.gov vehicle id 48826 (2025 Ford Mustang / Automatic 10-spd / Rear-Wheel Drive)Retrieved Nov 21, 2026
Modeled acceleration
Modeled, not measured
- Data level B
Range only
The model can run, but at least one input is assumed, was transcribed only once, or has no measured basis. A range is shown, without a single most likely time.
The data level says how complete the sourced data is. It is not a measure of how close an estimate is to a measured time.
0–60 mph
4.56 – 5.41s
Varied across the assumption ranges
0–100 km/h
4.80 – 5.65s
Varied across the assumption ranges
Quarter mile
13.11 – 13.84s
Varied across the assumption ranges
Only a range is shown for this configuration: how far the result moves when the assumptions are varied across their ranges. No single most likely time is given, for the reasons listed below.
Why only a range is shown
- Rev limit: not published, so the model assumes it and varies it across a range.
- Drag and rolling resistance: there are no measured road-load coefficients matched to this configuration and no drag coefficient confirmed from the manufacturer, so they are assumed.
Assumption
Assumptions used for this configuration
The published specifications do not cover everything the model needs. The inputs below are assumptions: each has a most likely value and a range over which it is varied to produce the ranges above.
| Assumption | Most likely value | Range considered |
|---|---|---|
| Rev limit ÷ peak-power speed | 1.12 | 1.04 – 1.20 |
| Idle speed (rpm) | 800 | 700 – 900 |
| Torque at idle ÷ peak torque | 0.75 | 0.60 – 0.88 |
| Power lost between peak-power speed and the rev limit | 0.08 | 0.02 – 0.20 |
| Engine speed held at launch (rpm) | 2,400 | 1,680 – 3,120 |
| Gear-change time (s) | 0.25 | 0.15 – 0.40 |
| Share of drive kept during a gear change | 0.80 | 0.50 – 1.00 |
| Engine rotational inertia (kg·m²) | 0.20 | 0.10 – 0.35 |
| Drag coefficient (Cd) | 0.30 | 0.26 – 0.36 |
| Frontal area ÷ (width × height) | 0.84 | 0.78 – 0.88 |
| Rolling-resistance coefficient | 0.011 | 0.008 – 0.014 |
| Loaded tire radius ÷ nominal radius | 0.965 | 0.950 – 0.980 |
| Driveline efficiency | 0.89 | 0.85 – 0.92 |
| Share of weight on the front axle | 0.52 | 0.47 – 0.56 |
| Center-of-gravity height (m) | 0.54 | 0.50 – 0.59 |
| Rotational inertia per axle (kg·m²) | 2.2 | 1.5 – 3.5 |
| Grip multiplier (tire and surface variation) | 1.00 | 0.92 – 1.08 |
| Tire grip relative to an all-season tire | 1.05 | 0.92 – 1.30 |
Conditions of the modeled run
- Level road, no wind, air density 1.2 kg/m³
- Dry road: tire–road grip μ = 1.0, multiplied by the grip assumptions in the table above
- A driver of 75 kg added to the published vehicle mass
- Straight-line run on a closed course, timed from first movement with no 1-foot rollout
- Model version 0.3.0
Each range runs from the 5th to the 95th percentile of 200 runs of the model, each with every assumption drawn afresh from its range.
The range is how far the result moves when the assumptions move. It is not a statistical confidence interval against measured results.
Specifications and their sources
Each row gives the value, what kind of figure it is, where it comes from and how it was checked. Values are stored in SI units and shown in the units chosen in the Units menu. Where the source used another unit, the value as published is shown as well.
| Item | Value | Kind of figure | Source | Check |
|---|---|---|---|---|
| Peak power | 235 kWPublished as 315 hp | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Engine / SAE Horsepower / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
| Engine speed at peak power | 5,500 rpm | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Engine / SAE Horsepower / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
| Peak torque | 475 N·mPublished as 350 lb-ft | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Engine / SAE Torque / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
| Engine speed at peak torque | 3,000 rpm | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Engine / SAE Torque / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
| Rev limit | Not published | — | The sources used for this page do not give a single value of this figure for this exact configuration. It has not been filled in with a guess or a typical value. | — |
| Item | Value | Kind of figure | Source | Check |
|---|---|---|---|---|
| Gear ratios, first gear first | 4.696 / 2.985 / 2.146 / 1.769 / 1.52 / 1.275 / 1.00 / 0.854 / 0.689 / 0.636 | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Transmission / 10-speed automatic 1st-10th / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
| Final drive ratio | 3.15 | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Transmission / Final drive / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
| Tire size on the driven wheels | 235/55R17 | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Wheels / Standard wheel / Tire dimensions / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
| Item | Value | Kind of figure | Source | Check |
|---|---|---|---|---|
| Curb mass | 1,627 kgPublished as 3,588 lb | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Exterior dimensions / Est. curb weight, fastback automatic / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
| Wheelbase | 2,718 mmPublished as 107 in | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Exterior dimensions / Wheelbase / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
| Overall width | 1,915 mmPublished as 75.4 in | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Exterior dimensions / Overall width without mirrors / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
| Overall height | 1,397 mmPublished as 55 in | ClaimedPublished by the manufacturer | 2025 Mustang Technical Specifications (PDF)Ford Motor CompanyWhere in the source: Exterior dimensions / Overall height, fastback / Mustang EcoBoost columnRetrieved Nov 21, 2026 | Transcribed twice, results agree |
“Transcribed twice” means two independent readings of the source gave the same value. It confirms that the source was copied correctly, not that the source itself is right.
Before you rely on this page
- The modeled times have not been compared with instrumented tests of this vehicle. Read them as estimates from stated inputs, not as predictions of a measured result.
- This site is independent. It is not affiliated with, sponsored by or approved by the manufacturer of this vehicle or by anyone who sells it. The make and model names are used only to say which vehicle the figures describe.
- The specifications are taken one figure at a time from the sources linked above. A source can contain an error, and a manufacturer can change a specification during a model year.
If a figure on this page is wrong, or should be removed, tell us and include a source.